Tipton Gas Get a free quote
Gas Safe registered · Tipton

Glow-worm F75 Fault Code in Tipton

Glow-worm showing F75 in Tipton? The boiler did not see the pressure rise it expected when the pump started. Safe checks and next steps.

Same-day breakdowns Fixed prices No call-out fee
  • Gas Safe registered engineers
  • Fully insured, work guaranteed
  • Fixed prices, no call-out fee
  • Local to Tipton & Sandwell

Each time a Glow-worm starts its pump, it watches for a small rise in pressure. F75 means that rise did not happen. The boiler takes that to mean the pump, the pressure sensor or the water level is not right, and stops.

Low pressure is the first thing to rule out. After that, the usual suspects are a sticking pump, a failing pressure sensor, or air in the system. Your manual will confirm the meaning for your model.

Plenty of Tipton homes have had radiators moved or added during kitchen and extension work. Air trapped after that kind of job is a common reason for F75 on the first cold week.

Good to know

Common Glow-worm F75 Fault Code questions

Is F75 a safety issue?

The boiler stopped because the water side did not check out. It is protecting itself. Smell gas? Get everyone outside, leave switches alone and call 0800 111 999, the National Gas Emergency line. A code on the display is not a leak. A smell might be.

It started after new radiators went in.

That points to air in the system. Bleeding and topping up may fix it. If not, the pump may need help to clear an airlock.

Does it mean a new pump?

Not always. Low pressure or air are more common. A pump or sensor is only replaced once those are ruled out.

What's involved

Glow-worm F75 Fault Code in Tipton, the right way

Look at the gauge

If the pressure is low, top up using the filling loop as your manual shows. Then reset once.

Bleed the radiators

Cold tops on upstairs radiators mean air. Bleed them with a radiator key, then check the gauge again and top up if it has dropped.

Listen for the pump

A pump that buzzes, knocks or stays silent is useful to mention. It helps pin down the fault.

What the engineer checks

The pump, the pressure sensor, the expansion vessel and any trapped air. On older systems, sludge can slow the pump as well.

What to send

A photo of F75 on the display and of the gauge, plus a note on any recent plumbing work. That often explains the fault on its own.

More from Tipton Gas

Also from Tipton Gas

Get in touch

Book a Gas Safe engineer in Tipton

Homeowner or landlord, we've got Tipton covered: repairs, servicing, installs and certificates. Leave your details and a local engineer will get back to you fast.

Send a photo of the problem on WhatsApp for the quickest reply, or give us a call. You get a free, no-obligation quote, usually the same day.

WhatsApp us