Tipton Gas Get a free quote
Gas Safe registered · Tipton

Worcester Bosch D5 Fault Code in Tipton

Worcester Bosch showing D5 in Tipton? It usually points at a temperature sensor, most often the flow sensor. What it means and what an engineer will do.

Same-day breakdowns Fixed prices No call-out fee
  • Gas Safe registered engineers
  • Fully insured, work guaranteed
  • Fixed prices, no call-out fee
  • Local to Tipton & Sandwell

D5 on a Worcester Bosch usually means the boiler is getting a reading it cannot trust from a temperature sensor. On many Greenstar models that is the flow sensor. On some it relates to an outside sensor if one is fitted. Your manual will say which applies to yours.

Sensors tell the boiler how hot the water is. If a reading is missing or makes no sense, the boiler stops rather than guess. The fault is often the sensor itself or the wire and plug that connect it.

Worcester boilers are a common upgrade in Tipton, often fitted in place of old floor-standing units in Great Bridge and Princes End. A boiler moved into a new spot sometimes has wiring that gets knocked during later work.

Good to know

Common Worcester Bosch D5 Fault Code questions

Is D5 dangerous?

No. The boiler stopped because it could not read a temperature. Smell gas? Get everyone outside, leave switches alone and call 0800 111 999, the National Gas Emergency line. A code on the display is not a leak. A smell might be.

Will the hot water still work?

Usually not while the code is showing. The boiler needs the reading before it will heat anything.

Is it a big repair?

Normally not. A sensor or its lead is one of the simpler boiler repairs.

What's involved

Worcester Bosch D5 Fault Code in Tipton, the right way

Power off and on

Switch the boiler off at the fused spur, wait a minute, then turn it back on and reset once. If D5 returns, leave it off.

Any recent work nearby?

Mention if cupboards were fitted or pipes boxed in near the boiler. A disturbed plug or lead is a common cause.

Leave the case alone

Sensors sit inside the casing. Testing them is a job for an engineer with a meter.

What the engineer does

Tests the sensor, its lead and the connection at the circuit board. A sensor is usually a quick part to replace.

What to send

A photo of D5 on the display and of the boiler label. Say if you have an outside sensor on a wall.

More from Tipton Gas

Also from Tipton Gas

Get in touch

Book a Gas Safe engineer in Tipton

Homeowner or landlord, we've got Tipton covered: repairs, servicing, installs and certificates. Leave your details and a local engineer will get back to you fast.

Send a photo of the problem on WhatsApp for the quickest reply, or give us a call. You get a free, no-obligation quote, usually the same day.

WhatsApp us